ChatterBox
SubscriberCan anyone help me with some measurements of the bull bar mounting holes on the front of a Perentie chassis, as indicated in the below picture.
I've had a couple of inquiries about whether I can modify the standard Defender Tube Bar to fit the Perentie.
If someone happens to have a spare Perentie sitting around with the bull bar removed I would appreciate any help.
Cheers, Murray
'88 County Isuzu 4Bd1 Turbo Intercooled, '96 Defender 130 CC VNT
'85 Isuzu 120 Trayback, '72 SIIA SWB Diesel Soft Top
'56 SI Ute Cab
Master
Yes. Its off for new bolts (and nuts and washers)($ monday), a different bar, a clean down and a check to see if there was any dis-similar metal corrosion too.
I have a tape measure, is that accurate enough?
As for G & H, the bolt hole diameters, well all my bolts are the same diameter and length, so I will double check, but I'd say they are the same diameter.
Master
Wow, its cold out there.
Allow for shiver factor and zero steel carpentry experience.
A: 830mm
B: 120mm
C: 120mm
D: 42mm
E: 58mm
F: 136mm (more difficult, measured by line of sight)
G: 13.5mm or 14mm ( the holes on the actual bullbar are 13mm )
H: 13.5mm or 14mm ( the holes on the actual bullbar are 13mm )
I measured the G & H on all holes. I measured B & C & D in more than one place.
ChatterBox
SubscriberThanks for braving the cold mate, that's certainly accurate enough for me to see if the modification is possible or not, I'll draw it up when I get a chance and see how we go.Originally Posted by Carzee
Cheers, Murray
'88 County Isuzu 4Bd1 Turbo Intercooled, '96 Defender 130 CC VNT
'85 Isuzu 120 Trayback, '72 SIIA SWB Diesel Soft Top
'56 SI Ute Cab
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Reply With Quote
Bookmarks