Results 1 to 3 of 3

Thread: TD5 Rocker Cover Gasket....

  1. 11th May 2016, 10:31 PM #1
    3 Lions's Avatar
    3 Lions
    3 Lions is offline Master
    Join Date
    Jul 2007
    Location
    Geelong area, Victoria.
    Posts
    264
    Total Downloaded
    0

    TD5 Rocker Cover Gasket....

    Just a quick question.....

    I have replaced the rocker cover gasket and ECU injector loom (due to Oil in the loom to the ECU)

    Is their an order of tightening the bolts down?

    I cannot find anything, only that it is to 9Nm.

    Or just go opposite to each other and work my way along....

    Regards,

    Col.
    Reply With Quote Reply With Quote
  2. 12th May 2016, 10:06 AM #2
    Tombie Guest
    My preferred order is centre, then alternate sides and front/back...

    Do them lightly and then go over again tensioning to final value.
    Reply With Quote Reply With Quote
  3. 13th May 2016, 12:45 AM #3
    jimr1
    jimr1 is offline Wizard
    Join Date
    Jul 2012
    Location
    ferntree gully australia
    Posts
    1,408
    Total Downloaded
    0
    A little tip put some gasket sealer at the back where it is semi circular . Make sure it is as clean As ! Check it's nice and clean with some kitchen roll , or equivalent . They tend to leak there if you do them dry !!.. Jim
    Reply With Quote Reply With Quote
« Do I need four bonnet stops for bonnet mounted spare? | Jerry cans storing on there side »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!