I don’t think I’ll ever run out of usb or power sockets ever again https://www.aulro.com/mobile-gallery...f3e1be5b27.jpg
Printable View
I don’t think I’ll ever run out of usb or power sockets ever again https://www.aulro.com/mobile-gallery...f3e1be5b27.jpg
Looks about the same as where we put ours.
Just need to fix the cracked gear stick now
Me too. Think I'll just use black silicone.Quote:
Originally Posted by ezyrama
We have some very bad rattles emanating from the plastic trim that covers the rear seat mountings in our Puma 90 (2012).
https://uploads.tapatalk-cdn.com/202...2ccd08dbf9.jpg
I have been unable to find any diagrams as to how these go together. I have tried tighten the screws but the just turn and turn. I assume there is a nut or some fastener on the back.
We live on a dirt road which is very corrugated at present and these make so much noise!
Any clues as to how to tighten?
Cheers - Simon
Unclip and place some adhesive foam onto the plastic and then replace.Quote:
Originally Posted by travelrover
The screws are just “Scrivets” and cannot apply more tension.
Thanks TombieQuote:
Originally Posted by Tombie
I was coming to that conclusion. Will try and wedge them with some thin rubber or the adhesive foam.
Or could go for the full rear carpet..
I was thinking the same thing, either that or I have a super glue with a powder catalyst to build it up (Mine has a tiny hole where the rubber has broken away between 3rd and 5th), but I was a bit scared to use it as at 3500 psi strength, if any got onto the shaft, I would never be able to slide the cover off if I replace it.Quote:
Originally Posted by DiscoMick
I have an annoying rattle in the B pillar I have to find, sounds like its coming from behind the upper seat belt bolt inside the pillar. Tried holding anything and everything whilst driving but no luck. Further dismantling is required me thinks.
Mine has that too. I can't find the source.Quote:
Originally Posted by ezyrama