I have been wondering about this myself . Will be looking forward to any replies .
 Master
					
					
						Master
					
					
                                        
					
					
						Almost finished changing both front wheel bearings and looking for the latest thoughts on setting the seal. Does it sit 4mm below or flush with the fine lip protruding above?
seems to be a couple of thoughts on dr google. My manual is not specific.
Thanks in advance.
 Master
					
					
						Subscriber
					
					
						Master
					
					
						SubscriberI have been wondering about this myself . Will be looking forward to any replies .
My seal had 3mm written on it but as long as it doesn't protrude past the hub it should be fine.
G
Use the axle drive flange as a tool to knock the seal in. Just drive it in until the flange hits the hub and it will be nice and even and the correct depth.
I've done mine that way for years since reading it on here (thanks JC).
Steve
1985 County - Isuzu 4bd1 with HX30W turbo, LT95, 255/85-16 KM2's
1988 120 with rust and potential
1999 300tdi 130 single cab - "stock as bro"
2003 D2a Td5 - the boss's daily drive
| Search AULRO.com ONLY! | Search All the Web! | 
|---|
|  |  | 
Bookmarks