Thread: Mulgo Defender Pop-Top

I've seen a 130 on carsales or gt recently that has 2 buckets in the back

Originally Posted by Colmoore

I've seen a 130 on carsales or gt recently that has 2 buckets in the back

Seats:

I have two exmoor bucket seats for the middle row that are yet to be fitted due to missing bits. These seats will bolt straight on to a TD5 or older truck, but need a plastic wedge for the puma. If you are ordering these please make sure you get the wedges as well.

Compliance:

I have quotes around $550 ~ $660 for a compliance certificate


You will need Buckles that needs to be bolted to foor:

Floor mounted front seat Buckles from older defenders will do the job.

Purchase:

I purchased mine from local disti, but i am told importing direct might save you $$. Local Disti is just an importing agent at best.

Originally Posted by dazzler

Complete storage inc Drifta, fridge slide, water tank is ready to come out next weekend, let me know if anyone is interested before I put it on gumtree

Have you got a link to the Gumtree ad?

Originally Posted by Fubar

Have you got a link to the Gumtree ad?

Hi Mate,

Its gone for a song to a member, will be installed to a 130 poptop conversion.

Originally Posted by dazzler

Seats:

I have two exmoor bucket seats for the middle row that are yet to be fitted due to missing bits. These seats will bolt straight on to a TD5 or older truck, but need a plastic wedge for the puma. If you are ordering these please make sure you get the wedges as well.

Compliance:

I have quotes around $550 ~ $660 for a compliance certificate


You will need Buckles that needs to be bolted to foor:

Floor mounted front seat Buckles from older defenders will do the job.

Purchase:

I purchased mine from local disti, but i am told importing direct might save you $$. Local Disti is just an importing agent at best.

Thanks Dazzler.
I'm going to start a new thread on fitting late model seats to my td5, if there's not already something on here?

Originally Posted by Colmoore

Thanks Dazzler.
I'm going to start a new thread on fitting late model seats to my td5, if there's not already something on here?

Hi Col,

Front are a straight swap, middle row needs a little bit of work if you are going down the puma seats into rd5 route, but doable

Fit Defender Tdci PUMA second row seats into your LAnd Rover ...

PM me if you haven't you sourced your seats yet. I have a set of middle row seats available from mid Jan.

pd

Originally Posted by weeds

Mulgo you can open from the inside therefore if it's pouring rain, hail or snow no need to get out of the car, we have used this once and realize the benefit....Icarus the latches are on the outside which maybe be inviting to a thief

That alone could be the deciding factor here in Oz.

Thanks dazzler, I've already got seats, brackets and seat belts.
I've seen that vid before - not sure it would pass inspection in NSW! Although the factory seat install in my 130 is a joke anyway!!
I've not really looked at a puma 130 rear seat setup, but I figure they must have done away with the storage box under the rear seats in favour of the angled box the same as the puma 110?
I'm thinking I might remove the square box and just get a box from a wrecked puma 110 and use it, then make up a mount point for the rear fold down bars.
At least that would be factory so I can avoid engineering.
Not going to get it done in time for Tassie though; might have to get the kids full face helmets for Xmas....