Thread: Limp Mode.....Help!

I would bet a turbo hose as well.

Regards,
Tote

hi Paul,
I had the same problem down at Torquay. Had to limp to Port Campbell. The inlet manifold hose right down the bottom split. I put my hand right down to feel the split. Its a short angled hose that splits. There is a silicon hose to replace it in England.
Its a big job to replace it. All those coolent hoses have to come out of the way.

..... had mine done at Geelong Landrover using a standard hose. Last day of my landrover assist too. I meant to ask what the bill would have been

Thanks guys, is there any way I can say for sure this is the problem? Is the best place to look from above or from beneath the vehicle.

I think the 1500m climb up Mount Kapatur may have led to this failure!

So I read the fault codes and have the following:

P0101 - Powertrain
Mass or volume Air Flow Circuit Range / Performance Problem

P2263 - Powertrain
Turbo / Supercharger Boost System Performance

Think this finalizes the problem. Does anybody know which part of the turbo system to inspect first?

Originally Posted by PAUL200

So I read the fault codes and have the following:

P0101 - Powertrain
Mass or volume Air Flow Circuit Range / Performance Problem

P2263 - Powertrain
Turbo / Supercharger Boost System Performance

Think this finalizes the problem. Does anybody know which part of the turbo system to inspect first?

I'd say your one of your hoses has gone. Replace them all with silicone ones

One of your turbo hoses has either come off or is split.
If it's simply come off, then reattach and tighten the clamp.
if it's split, and I'm assuming that you're still around the Narrabri area, then I'd suggest you get some Self Fusing Silicone Rescue Tape from one of the local auto shops. Do a temporary fix on the split which will get you back to Sydney where you can then order and fit a set of silicone hoses ....... and make sure they're secure not rubbing on anything.

I did this on a friends 110 Puma in the Victorian High Country and he completed the trip and drove back to Sydney with the temporary repair.

Originally Posted by Xtreme

... get some Self Fusing Silicone Rescue Tape ...I did this on a friends 110 Puma ...

I was going to ask you if you always carry the Self Fusing Silicone Rescue Tape, but then I looked up what it was.

Look what you can do!

extract from Self Fusing Silicone Rescue Tape


What Will it Repair
Recommended for repairs to hoses, pipes, air lines, air-conditioning pipework, exhausts, fuel lines and a host of other conduits that fail on a regular basis, this stuff is limited only your own inventiveness.
The snake-oil salesman at the boat show demonstrated how an emergency fan belt could be constructed by lashing the tape around the pulleys of an engine and while we haven't needed to try it we have no doubt it would work.
The promotional blurb also states that self fusing tape has "7000 volts dielectric strength after elongation'' meaning it is a very safe insulator for spark plug leads, electrical car coils, power tools, electric leads etc. etc. etc.