Thread: Defender 200 Tdi air intake measurement

I dont know, but think the 300 has it on the RHS and the 200 on the left but I imagine if its a custom install either would work.

K

They are completely different.

Originally Posted by Red90

They are completely different.

Are they? I think OP is talking about the exterior vent position on the outer wing skin, asking if it LHS is a mirror of RHS vent.

Having just ordered vented skins for both sides, I wouldnt be suprised if they are exact mirrors.

Whats the plan here Sly?

Originally Posted by manic

Are they? I think OP is talking about the exterior vent position on the outer wing skin, asking if it LHS is a mirror of RHS vent.

Having just ordered vented skins for both sides, I wouldnt be suprised if they are exact mirrors.

Whats the plan here Sly?

Thats what im talking about .

Thinking about cutting in a vent on left hand side , would like them to be even / match up .

The vent is recessed into the wing so a cut wont look the same but to draw exact mirror you could take off your outer skins and lay them face to face.

What you could do is get a pair of flat aluminium vent grills and add a spacer on one side so both sit proud of the skin.

I went with plastic replacement outer wing skins for 300tdi and 200tdi, so both will have factory vents recessed. I would have done the cut but I removed a snorkel and the wing is a mess underneath.

Intake will be taken from wing top so both side vents will be for moving air through the engine bay.

Originally Posted by manic

I went with plastic replacement outer wing skins for 300tdi and 200tdi,

where do you get plastic skins from?