Thread: Spotlight installation - Auto electrician recommendation (Sydney)

I think nugget stuff sells the correct factory looking switch to go into the unused spot.

Sorry cannot help you on the auto elec side

Whoops, the one I was thinking is additional switches once all the OEM spots are used

Nugget Stuff Defender 2 Switch Bezel – Nugget Stuff

Originally Posted by weeds

Whoops, the one I was thinking is additional switches once all the OEM spots are used

Nugget Stuff Defender 2 Switch Bezel – Nugget Stuff

Nugget does the bezel for adding additional pairs of switch’s.

Mulgo/ Expedition Centre do the OEM looking switches including the plug to wire them in.
Auxiliary Switches for Defender 2002 onwards - Mulgo

Fitting a set of spotlights is possibly one of the easiest Mods that can be done on your 4WD.
Most manufacturers can supply a wiring loom complete with fuses and relays for the job along with an installation procedure, Why not install them yourself and not only save on a sparky bill but also get the satisfaction of doing the job yourself
After all you own a Landrover and this won't be the only time you will need to get on the spanners.

Originally Posted by trout1105

Fitting a set of spotlights is possibly one of the easiest Mods that can be done on your 4WD.
Most manufacturers can supply a wiring loom complete with fuses and relays for the job along with an installation procedure, Why not install them yourself and not only save on a sparky bill but also get the satisfaction of doing the job yourself
After all you own a Landrover and this won't be the only time you will need to get on the spanners.

Good point.....but these days I pay others to carry out my maintenance as I’m time poor.....

Originally Posted by weeds

Good point.....but these days I pay others to carry out my maintenance as I’m time poor.....

It would most likely take longer just to hunt up a good sparky to do the job than it would to do the job yourself.

Originally Posted by trout1105

It would most likely take longer just to hunt up a good sparky to do the job than it would to do the job yourself.

Umm, 1/2hr break at work I reckon I could rustle up a good sparky....although that what I do for my job is find contractor at time.

Although driving lights I would do my self over six weekends.

But it’s not us, the OP sounds like he is committed to somebody installing, if he was in Brisbane I could give him a lead on who i use.

Originally Posted by BrianY

Was wondering if anyone has a good recommendation for a land rover auto-electrician in Sydney who could install this into one of the unused stock dashboard buttons?

Where are you located?