- 
	
		
                        
                                
                                        
                                                6th August 2018, 07:56 PM
                                        
                                
                                
                                        
                                                #1
                                        
                                        
                                        
                                
                        
		 
 
		
		
		
		
			Central Locking
		
 
			
				
					The passenger side rear door central locking does not work. (2003 TD5).  
 
 Checked this forum and took the advice offered - that is, check the continuity of the harness adjacent to the B pillar.  Turns out, its ok - no physical damage and proper continuity.
 
 Next step was to confirm that the door solenoid works - it does, up and down like a champion.
 
 Bit more checking indicates that only one of the two wires (pink and yellow) at the B pillar junction, shows a voltage when I cycle the central locking.
 
 So, does anyone
 
 have a suggestion regarding the fault?
 
 know how or where the rest of the central locking harness is routed through the vehicle?
 
 Thanks in advance for your help.
 
 
 
 
 
 
- 
	
		
                        
                                
                                        
                                                6th August 2018, 08:15 PM
                                        
                                
                                
                                        
                                                #2
                                        
                                        
                                        
                                
                        
		 
 
		
		
		
				
				
		
			
				
					One would assume the other wire would be negative and wire polarity reversed when opposite command is required.
				 
 
 
 
 
 
- 
	
		
                        
                                
                                        
                                                7th August 2018, 07:33 AM
                                        
                                
                                
                                        
                                                #3
                                        
                                        
                                        
                                
                        
		 
 
		
		
		
				
				
					
				
		
			
				
					If the solenoid works, and you're getting voltage where you should, then I would check the connector is clean and not damaged. Could be as simple as a loose pin or corroded terminals.
 
 Another suggestion is peer testing the solenoid, swap it out for a known working one and see if that functions in its place, or take the potentially faulty one and plug it in at a door that is known to work and see if it functions.
 
 
 
				
					Last edited by Graekynn; 7th August 2018 at 07:39 AM.
				
				
					Reason: Extra thought...
				
			 
 
 
 
 
	
	
	
	
	
	
	
	
	
	
	
	Tags for this Thread
	
	
	
		
		
		
		
			
				 Posting Permissions
				Posting Permissions
			
			
				
	
		- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-  
Forum Rules
 
			 
		 
	 
 
  
    | Search AULRO.com ONLY! 
 | Search All the Web! 
 | 
  
  
  
Bookmarks