Reply With QuoteMake sure the sensor is pushed home and check that wiring has not been damaged. If you have a nanocom clear the fault first and go for a drive and see if it rescuers.
Lindsay
Wizard
ABS Light on now after replacing Swivel Hub Seals - What have I done wrong?
Guys, I replaced the swivel hub ball and all the associated seals, etc and took it for a drive and noticed that that the ABS light on my MY10 Defender 110 stayed on. The only thing I can think of is that maybe the sensor needs pushing further in but I'm unsure if u can push them too far in?
Also, it this something I that I need to use my Nancom on to reset something in the ECU?? Unsure.... looking for advice here...
thanks in advance
Master
SubscriberMake sure the sensor is pushed home and check that wiring has not been damaged. If you have a nanocom clear the fault first and go for a drive and see if it rescuers.
Lindsay
RoverLord
Yep. Clear the fault first, see what happens. Worked for me. OK, I have a Disco, but it's pretty much the same.
JayTee
Nullus Anxietus
Cancer is gender blind.
2000 D2 TD5 Auto: Tins
1994 D1 300TDi Manual: Dave
1980 SIII Petrol Tray: Doris
OKApotamus #74
Nanocom, D2 TD5 only.
Wizard
OK... so when I had the swivel hub all apart - it looked like the sensor "could" be pushed in to the point where it actually could rub on the CV. We pushed it back in to the point where we thought it was but maybe it may just needs a little bit more??
I'll put the nanacom on it in the next couple of days and see what it says...
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks