Thread: 130 rear bulkhead waist seal setup

I'm looking for a workshop manual that covers setting up the gaps/tolerances for the truck cab (130) rear bulkhead to the window section

So it's essentially the rear waist seal for a truck cab gap.

Any single can or double cab model should be fine.

The seal part number is 333486.

I cannot find any reference in any of the numerous workshop manuals I have here that cover it, they all refer only to the wagon.

Also called pickup or cab chassis.

As no one has replied and I needed to get the job done, I went and looked at the 110 wagon rear setup. Whilst not the same as the 130 obviously, the principles and basic setup is very similar.

So I went with the wagon specs which are 0-4mm for the rear gap, parallel within 2mm.

Cheers