wheel speed issue.

Well, if Nanocom say it's all right, then I'm scratching my head! :eek:

I just did a moving test in the driveway with the Nanocom talking to the ABS computer.
I noted that all 4 sensor voltages were similar (within about .1 V of each other); both stationary and when moving.
At stationary, I had 3 wheels on 1.7km/h and one at 404.8km/h; then when moving, 3 wheels were doing 2.7km/h and the fourth was doing 396km/h!
(And I hadn't disabled TC; so I wasn't doing :burnrubber: either!)

So I suspect that the speed may be a miscalculation in converting the sensor volts/frequency into km/h.

:)
Geoff

which wheel sensor was it that had the high reading geoff?

cheers phil

Quote:

---

Originally Posted by thethink

... over the minimum detectable speed (about 2.5km/h from memory).

---

Whilst the D2 speedo wont show lesser speeds, the ABS ecu generates a distance/speed pulse for every 200mm travelled plus a 1hz base pulse.

Quote:

---

Originally Posted by discowhite

which wheel sensor was it that had the high reading geoff?

cheers phil

---

Left hand rear wheel. Same one as yours. ;)

Are you running firmware 2.03 on the Nanocom?

:)
Geoff

yep all up to date and 2.03..

cheers phil