clutch cover plates

[sykes1]

Hi all. can any body supply photo's of the,front of the bulkhead, just below the rubber bung,as i have plenty of spare holes to fill in, it is a 2a lwb maybe 67 and its a 6 cylinder bulk head too, any photos would be great, i think the aluminuim plates are missing from there, not sure what they should be

thanks Andrew

[JDNSW]

Not sure what you are referring to. In the Landrover 2a workshop manual, the clutch cover is what I would refer to as the pressure plate, but I don't think this is what you are after.

If you mean what blocks the holes in the bell housing - the one on top is blocked by the mounting bracket for the gear lever, the one on the left has a rubber grommet, and the one on the right has a rubber grommet that the clutch shaft goes through.

Or do you mean the floor panels?

John

[sykes1]

the panel on the bulk head, my memory is going ha ha, below the rubber bung

[UncleHo]

G'day Sykes1 :)


The panel you are refering to is the clutch housing cover panel or the rear engine cover housing, also known as the gearbox front cover housing :)



cheers

[peterg1001]

I think Andrew might be referring to the holes in the bulkhead where the hand throttle pokes through. If the hand throttle mounting plate is missing, there's a rectangular hole left over.

I've attached a photo, where the hand throttle hole has a cover plate over it. And is the rubber bung you're referring to the grommet for the speedo cable?

Peter