electronic rust wiring set up

[stig0000]

i have gotten a free ECI rust thingy from work, one prob is that the copper pad is missing, (resion why i have it) other then that it works fine,

just a qwick Q, there is only one wire that gose to the pad thingy and since thats ment to be metle on metel anyway, can i just put a spade conector on and run it on a post on the chassis/body,,

im not asking weather you think they work or no, i personally think they dont:D:wasntme:, BUT its FREE and im a freak about no rust, so you not try it out,

[Scouse]

i have gotten a free ECI rust thingy from work, Translation:
I pinched this off a car that was traded in at work :wasntme:.

[stig0000]

not this time round,:D:D:wasntme: all tho that is were my gen rubber floor mats and spear wheel cover came from:D, oh and my real sheep skin seat covers,

have to get somethings from dealers:wasntme:

[Bearman]

i have gotten a free ECI rust thingy from work, one prob is that the copper pad is missing, (resion why i have it) other then that it works fine,

just a qwick Q, there is only one wire that gose to the pad thingy and since thats ment to be metle on metel anyway, can i just put a spade conector on and run it on a post on the chassis/body,,

im not asking weather you think they work or no, i personally think they dont:D:wasntme:, BUT its FREE and im a freak about no rust, so you not try it out,

The unit I have has multiple anodes. There are about 12 single wires that come out of it and each wire goes to a sacraficial anode which is attached to the body with a thin strip of double sided adhesive. (the anode does not actually touch the body and the instructions said to make a scratch right down to the bare metal immediately under where the anode is to go)