PDA

View Full Version : Brush Bar


wayneg
30th September 2010, 05:12 PM
I just picked up a damaged genuine L/R Brush Bar from Linn Rover in Perth. The N/s wing is bent. Figured I would just use the central "A" bar which is fine with all the bolts and brackets. Then I thought some one might have a good N/S wing from another damaged bar. Think of me if you have .
996TURBO
30th September 2010, 09:19 PM
What involves the conversion from full brush bar to A-bar exactly?
adm333
30th September 2010, 10:39 PM
The side wings are simply bolted on with 2 or 3 bolts.
996TURBO
1st October 2010, 12:44 AM
The side wings are simply bolted on with 2 or 3 bolts.
Is there any cover or additionnal part to hide the holes?
Scouse
1st October 2010, 07:09 AM
Is there any cover or additionnal part to hide the holes?Looking at the EPC, you need STC8876 & STC8877 - they're described as LH & RH covers for the A frame nudge bar.
adm333
1st October 2010, 10:32 AM
From memory there are holes set in the rubber coating to put the bolts into. The nuts are already set into the bar.

There are small round rubber plugs that sit in the hole to cover.

Its all very neat.