1955 86' Seats

[Brad110]

I am about to make some front wood seat bases.

I believe my current wooden frames are original but I am after a picture/ diagram/ sketch of the original in order to verify this.

Can anyone EMail me any leads.

Regards Brad

bradonubique@gmail.com

[Landy Smurf]

i am sure someone will get back to you soon if not i might be able to get a few photos next tie i am at the cave, as i have some more photos to take

[digger]

Brad,
http://www.aulro.com/afvb/series-i-land-rover-enthusiasts-section/66623-advice-trim-please-2.html

post 4 page 1 may help... although the thread itself is probably handy :)

hope this helps.

digger

(Im sure there is more somewhere this is the only one I remembered!)

[Brad110]

I am going to make a few sets of bottom seat wooden frames. They will be of hardwood and same dimension as original with the tapered ends to fit into the seat locating slots. I will then \brace mine with plywood to provide extra support for the cushion.

I am yet to source vinyl for re-upholstery.

Anyone interested in timber frames? I would mill them but not assemble them in order to make post easier.

Regards brad

bradonubique@gmail.com

Mob 0427663754.

[123rover50]

Forgotten where I got these , but from a public forum somewhere.
Phil Perry drew them up

[Landy Smurf]

if you are going to make the bottoms use a solid piece of ply underneath as well it makes it a lot more stronger and stops it from sagging