Series 1 Parts Catalogue

[Scallops]

https://www.aulro.com/afvb/ (http://imageshack.us/photo/my-images/259/vehicles.gif/)

Complete catalogue of Series 1 Part numbers which can then be input to parts suppliers search functions. :)

[Gilski]

Thanks Scallops,

the parts lists are unbelievably helpful

[Scallops]

Thanks Scallops,

the parts lists are unbelievably helpful

That's what we aim to do - provide a resource. Glad it was of service to you. :)

[caebryn]

https://www.aulro.com/afvb/ (http://imageshack.us/photo/my-images/259/vehicles.gif/)

Complete catalogue of Series 1 Part numbers which can then be input to parts suppliers search functions. :)

Hi scallops ,how do I download a parts catalogue of series 1 and discovery 1 thanks Hayden

[The ho har's]

Hi scallops ,how do I download a parts catalogue of series 1 and discovery 1 thanks Hayden

You should just click on it and it will download. If you go into the "shop" at the top of the page left hand side there are several CD's that can be purchased which are very helpful.

[Scallops]

Hi scallops ,how do I download a parts catalogue of series 1 and discovery 1 thanks Hayden

As mentioned clicking on PDF link will open it......but these links are for the Series vehicle Series 1.......not a modern Discovery. I don’t have any links for them, but I’m sure their section of the forum will be able to help you out.

Dan.

[bruttabestia]

https://www.aulro.com/afvb/ (http://imageshack.us/photo/my-images/259/vehicles.gif/)

Complete catalogue of Series 1 Part numbers which can then be input to parts suppliers search functions. :)

Good afternoon, I need to reassemble the linkage of my 2 litre diesel and i need some help: the parts catalogue indicates 2 springs (item nr. 37, part nr. 277502) and 1 "anchor" ( item nr. 38, part nr. 277565) both on page 155 of the Series 1 parts catalogue ( it the same setup for the Series 2 , 2 litre diesel).

Can anybody post a picture of an engine where i can see how both springs and anchor need to be fixed, please ?

Thanks a lot

[JDNSW]

The location of the springs is shown on page 5-A2 in the Series 2a manual. The throttle return spring is between the lever on the side of the pump and the shaft of the bell crank that is on a bracket bolted to the top of the pump. The return spring for the stop lever goes to a teardrop shaped bracket held by the upper bolt holding the oil filter adapter, directly below the lever. Looking at a couple of different manual pictures, it seems likely that the setup may have varied somewhat during 2 litre production! (or some of the pictures are from prototypes!)