gasman
23rd July 2013, 08:58 AM
No, i'm not. I want to know if anyone has modified the dash in A 110 PUMA UTE.
My left knee hits the angled dash panel next to the centre stack and my right knee jumps up and down on the the little tray/shelf under the tiller.
The seat is as far back as it will go without my body being at an acute angle as driving Uncle Buck is hard enough, thanks.
Since I don't have the bucks or equipment to extend the rear of the cab which is the preferred option, I want to remove some of the dash to free up some much needed space.
If anyone know of a motor trimmer that moulds plastics, well that will be the answer. I will cut out the offending pieces and remould new pieces in to make it look factory.
Right. Now its your turn and don't worry about offending me, I drive a Land Rover.............
My left knee hits the angled dash panel next to the centre stack and my right knee jumps up and down on the the little tray/shelf under the tiller.
The seat is as far back as it will go without my body being at an acute angle as driving Uncle Buck is hard enough, thanks.
Since I don't have the bucks or equipment to extend the rear of the cab which is the preferred option, I want to remove some of the dash to free up some much needed space.
If anyone know of a motor trimmer that moulds plastics, well that will be the answer. I will cut out the offending pieces and remould new pieces in to make it look factory.
Right. Now its your turn and don't worry about offending me, I drive a Land Rover.............