BenN
17th September 2013, 04:44 AM
I'm getting a steady leak from the gasket between the water pump and the engine in my tdci.  Is there a trick to this?  
I am on my second gasket and don't want to ruin it.  I don't think the pump is bad.  Do people use gasket sealer?
newhue
20th September 2013, 03:08 PM
are both surfaces mickey mouse.  To clean surfaces i use a hack saw blade that's been broken in half, and the width ways edge smoothed and sharpened on a bench grinder.  Gem razor blade will do the same.  The surfaces need to be free from the previous gasket.  Generally speaking the gasket should do the sealing.  Gasket goob is a secondary thing,  or something that caters for slight warping or imperfection perhaps. Insurance so to speak, but not required. 
I have read Tdi owners have suffered from slightly warped housing with P gaskets.  Warping may be something to check for, are the surfaces flat? Can a steel ruler be run over them and maintain surface connection.
Powered by vBulletin® Version 4.2.4 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.