Range rover classic bull bar onto D1

[TriPolar]

Will it work? Found a cheap winch compatible one that i want. Said it was off a range rover classic, its also a ARB one. Cheers.

[Reads90]

I have tried it in the past and does not fit. The RRC is a lot squarer than the Disco although they don't look like it they are.

This is very noticeable when you put a RRC bull bar onto a Disco. Front center is fine but gets worse as you go towards the headlights and corners.

[TriPolar]

How bad is bad? As i found a near new (looks bloody good) with light force light force lights for $450..

[Reads90]

Not pretty looks from far it's not the right bull bar.

Buy it keep the lights and out it on eBay for $300.

$150 cheap for light force lights.

[TriPolar]

Bugger. I dont care much for the lights, im just after a nice bullbar. 1.1K for a xrox one is the next option :(

[disco_ute]

Bugger. I dont care much for the lights, im just after a nice bullbar. 1.1K for a xrox one is the next option :(

I have a rrc ARB bar on my d1 looks fine to me. Less over hang. Will post a pic later if you can see the image in my avatar.
Mick

[Reads90]

I have an old ARB one for a disco. Does not have a winch bit yet but strong enough for a winch.

I am about to put it on eBay

Same looking as the one you are looking at on gumtree but without the winch.

I am in Brisbane

[pop058]

Took the bar off my old 88 RRC and it bolted straight up on my 97 Disco. (The white D1 in the pic:D)

All I had to do was trim the plastic bits under the headlights.

[TriPolar]

Prob the same one i already have. Its ARB and is pretty solid, the winch mounts to the front not the bottom. Just on the look out for a bargain:
https://fbcdn-sphotos-h-a.akamaihd.net/hphotos-ak-frc3/t31/1500953_673371929381558_371303674_o.jpg

For the bar i mentioned for sale:
Land Rover Discovery Range Rover fitting Bull Bar with Spots | Other Parts & Accessories | Gumtree Australia Brisbane North West - Milton | 1037109984 (http://www.gumtree.com.au/s-ad/milton/other-parts-accessories/land-rover-discovery-range-rover-fitting-bull-bar-with-spots/1037109984)

[pop058]

This is the bar when on my RRC. Don't remember the brand.

[BigJon]

They can't be too far out as I have Disco I bar on my Rangie.

[disco_ute]

With a high mount winch I had to cut the grill... and the bar won't line up with lra flares..

[Saitch]

Just remember about air bag compatibility, if applicable. I had an '85 RRC bar on our D1 (had to weld adaptor plates on it) & found out that my insurance would be null & void in an accident because the bar was not air bag friendly.