Isuzu / LT95 spiggot bush loose. (AYG320).

[circlework]

Hey all,
I had cause to remove the LT95 from my Perentie yesterday (don't ask!) and on inspection of the spigot bush assembly, found I could turn it in situ, with finger pressure. After reading this thread: http://www.aulro.com/afvb/projects-tutorials/84329-how-remove-4bd1-spigot-bearing-housing.html
I'm assuming the steel spigot extension should be at the least, an interference fit into the crank recess, is this correct?

Any help greatly appreciated.
Thanks,
Daryl.

[Blknight.aus]

near enough.

hit it with some 680 or 690 and put it back.

[circlework]

near enough.

hit it with some 680 or 690 and put it back.


Sounds good, thanks. Might make sure it's concentric before doing the 680.


Cheers.