EAS valve block diagram - thanks Paul

[SpiggyTopes]

Hi All,

I got stuck with my valve block overhaul and was saved by Paul's schematic:


https://www.dropbox.com/s/7k9yv70gi2ppqms/EAS-ValveBlock-v1.5.pdf'dl=0

I had swapped solenoids 6 and 7 .....

Thanks Paul - I was able to follow the wires from solenoid to multiplug and correct the error.

I hope it's ok top post the link here, if not, please delete it.

Cheers

[p38arover]

Paul,

would you like to add it to the AULRO Files section?

[PaulP38a]

Paul,

would you like to add it to the AULRO Files section?

Sure Ron, use the copy in Spiggy's post, or the source at
http://hardrange.com/downloads/manual/EAS-ValveBlock-v1.5.pdf

I may yet update the EAS Valve Block Rebuild Guide over the Chrissy break, and will re-home the diagram from hardrange.com to paulp38a.com.
hardrange.com isn't going anywhere yet, but I won't be maintaining it much any more, just keep security patched and host updated.

Cheers, Paul.

[poleonpom]

I used Paul's diagram when I did mine. Got me out of a right pickle.
Don't know if I thanked you at the time, so Thanks Paul!

[forget]

awesome diagram, will help me when I do my rebuild of valve block.


I sprayed soapy water around looking for leaks and I have leaking seals on the dryer and I had bubbles coming out of the top of the valve block between the non return valve and main block and also had bubbles come out of the exhaust silencer, so I think I need to replace orings.


Question is what size orings are they or where's the best place to get a kit made up.


regards


Shane

[daf11e]

Shane' the kits consisting of all o rings and diaphram are available on e bay.... I Would post a link but can't seem to get it on........ I Am sure someone will for you.....also paulP38a has a great. Step by step write up

[daf11e]

I think a good supplier is Scotty at WWW.BECMDOCTOR.COM (http://www.becmdoctor.com)........

[forget]

ive cheched it out further and its only leaking from the tank return line and my front left airbag at the valve block


does anyone know the sizes of these o rings


im guessing that inside diameter would be 8mm and 6mm but I need the thickness of both


ive been to 3 range rover specialists and none of them know the size, just get a kit off ebay they say.
problem is the kits in England and I need to get mobile ASAP.


thanks

[poleonpom]

Hey Shane,
Sometimes the pipe gets scored and then leaks, just pull it out and have a look.
The other thing to get is a set of schrader valves, you can disable the EAS and then pump each corner manually.