Camshaft Disco 2

[Disco Alex]

I want to replace the camshaft in my Disco 2 4.0L engine while I have it in a million pieces. Looking to maybe get one that gives it some more torque. But not sure where to get it from. Anybody know what is available and where to get it ? :thumbsup:

[Disco Alex]

Thought I would get at least one reply.........:(

[ozscott]

Mate i will hunt for the receipt for mine. It was a Crowe cam from memory...second stage tow cam. Cheers

[Pedro_The_Swift]

Do you want one made in Oz?
Mines a H180 Kent cam from England.
Any company that can grind a cam can do one.
This from Crow

[CountP]

Do you want one made in Oz?
Mines a H180 Kent cam from England.
Any company that can grind a cam can do one.
This from Crow

Any company that can grind a cam, can grind a Kent profile but do they harden it correctly so that in 100km you aren't pulling the cam out again.
Spend the extra money and get a billet cam.

[ozscott]

Ok mate this is mine

371613 - RANGE ROVER 4.6 HI TORQ CAM - 371613 - RANGE ROVER : CrowCams (http://www.crowcams.com.au/FindaProduct/tabid/92/ProdID/16467/371613__RANGE_ROVER_46_HI_TORQ_CAM.aspx)

Certainly gave it more urge in middle rev range - more towing torque. You could tell it was not stock without a load but more noticeable with a load - with a heavy load you could tell the difference, although the difference was not huge. I wouldnt go with this cam unless towing all the time. I understand that the High Compression 4.6's cam has higher and longer valve opening.

Cheers

[Roverlord off road spares]

Make sure you replace the lifter alsoo , other wise you end up like others with premature wear.

[Disco Alex]

So, ozscott, will this cam suit a 4.0L Hi comp engine ?

[ozscott]

Mate mine is a high comp 4.0 D2, late 2001 build before the d2a. I did lifters too...

Cheers