Alternator not charging after Burst pipe incident.

[nic_denmark]

Hi All,

After the thermostat housing blew on my landy (cause was rust)
Which is now fixed with an aluminium welded pipe.
I start it up and runs well but alternator not charging....

why....? why would this go at same time.!? ive cleaned connections, tightened belt...

and get this Izuzu dealer quoted $2000!!!!!!!!!!!!!

Part number from all4x4s... 8941754481.

Any help much appreciated.:angel:

[Blknight.aus]

slip rings not making contact, sense wire connection gave up with the dousing/heat

[flagg]

check for lose wires as well...

There are other non-genuine alts that are available that cost a whole lot less than 2k. if you search around on here and in the part numbers sticky thread you'll be able to get one for a few hundred.

[nic_denmark]

Found one with extenal regulator and was $490 inc.. still alot of money but least landy back on road now.

Was abit of a nightmare but thanks for help with sticky etc.

Welded ali thermo housing up and cost $60
fingers crosed no more bills for a while. skint

[Jode]

There's a company (hc cargo) in Esbjerg, if I remember correctly, that makes rebuild kits (slip ring, voltage regulator, rectifier and bearings) for some alternators, so you may be able to rebuild your old unit and keep it for a spare. P?j p?j.