Distributor Bracket

[tibbsy]

Hey,

Is there a bracket between the distributor and the engine block? There are 3 threaded holes in the block where the distributor fits into the engine block, but I don't seem to have the bracket (or hardware).

Can someone post a pic? Would anyone have a spare bracket?

Cheers

Tibbsy

[mick88]

Do you mean theses three holes around where the distributor drops into place?


If so there is a triangular shaped alloy plate that the distributor clamp bolts onto and the distributor can then be rotated to adjust the ignition timing.


Cheers, Mick.

[whitehillbilly64]

Hi Mick,
My engine gasket set came with a paper and alloy triangular gasket.
Which should I use
Thanks

whitehillbilly

[crackers]

I pulled my dizzy off the other day, not realising it had that triangular base, and it had the paper gasket (by 'paper', it was a normal gasket). I put it straight back on so I don't know if it had both.

[tibbsy]

Mick,

Thanks that is the part I'm looking for!! Great pick too, now I just have to find one.

Tibbsy

[mick88]

Hi Mick,
My engine gasket set came with a paper and alloy triangular gasket.
Which should I use
Thanks

whitehillbilly


The paper one does the job Billy.
I am not certain but I think the alloy one may be for the diesel engine.


Cheers, Mick.

[tibbsy]

Does anyone know the part number for this alloy plate?

[newby@54]

Mick


I think it is part # 247672 - 'adaptor for distributor'.


Nic

[whitehillbilly64]

Thanks for the replies.

whitehillbillies

[Wazzaorange]

I am having some issues with the plate I have. I have one with a dome underneath?. Not the plate seen in the picture. As my plate is damaged I have located another one ( same as the picture) but now my distributor will not fit? The distributor is too long it seems?

Wrong distributor or wrong bracket? Any suggestions?..

Cheers wazza