rfurzer
7th December 2015, 08:56 PM
Gday
Wasn't sure whether to put this here, in the Isuzu section or the Perentie section.
The Tas motor registration officials are about to cut up rough with Perenties on a few points to do with ADR's.
One of these is the suspension/ ride height. They point me to this document
Road Vehicle Descriptor (RVD1) (http://rvcs-prodweb.dot.gov.au/perl/9419_954452_RVD_11Oct2011100503.cmd)
This sounds like a newer Defender rather than a county / 110 of 1988 vintage. It gives front height 560mm, rear 590 measured from wheel centre to wheel arch.
I cannot find any land rover data for a civilian 110 of 1988 vintage after a bit of a search- can anyone help?
Wasn't sure whether to put this here, in the Isuzu section or the Perentie section.
The Tas motor registration officials are about to cut up rough with Perenties on a few points to do with ADR's.
One of these is the suspension/ ride height. They point me to this document
Road Vehicle Descriptor (RVD1) (http://rvcs-prodweb.dot.gov.au/perl/9419_954452_RVD_11Oct2011100503.cmd)
This sounds like a newer Defender rather than a county / 110 of 1988 vintage. It gives front height 560mm, rear 590 measured from wheel centre to wheel arch.
I cannot find any land rover data for a civilian 110 of 1988 vintage after a bit of a search- can anyone help?