county suspension height

[rfurzer]

Gday

Wasn't sure whether to put this here, in the Isuzu section or the Perentie section.

The Tas motor registration officials are about to cut up rough with Perenties on a few points to do with ADR's.

One of these is the suspension/ ride height. They point me to this document

Road Vehicle Descriptor (RVD1)

This sounds like a newer Defender rather than a county / 110 of 1988 vintage. It gives front height 560mm, rear 590 measured from wheel centre to wheel arch.

I cannot find any land rover data for a civilian 110 of 1988 vintage after a bit of a search- can anyone help?

[rfurzer]

Here we go!