PDA

View Full Version : Ride height settings


4x4instyle
12th October 2016, 12:06 PM
Hi can the ride height auto change at 50klms be adjusted so it stays on or set to 90klms eg;? All tips welcome. 4x4instyle
Graeme
12th October 2016, 05:02 PM
The Llams kit that I produce allows off-road height and other heights to be achieved whilst at normal height and therefore without any speed restriction. The kit is plug-in for MY07-12 but hard-wired for earlier models. If you PM me your email address I'll send you information on the kit.
chaybra
17th October 2016, 07:12 AM
also IID tool will do the trick.


but i just went to bunnings and spent the $7 for some angle alloy and tricked the sensors to make it higher
Steinzy
26th October 2016, 10:29 PM
What programming on the IID tool did you use to stop ride height from adjusting over 50 km. Would be also useful to stop ride height from going to standard height when trailer connected....not useful with an off road camper!
Tombie
27th October 2016, 10:47 AM
What programming on the IID tool did you use to stop ride height from adjusting over 50 km. Would be also useful to stop ride height from going to standard height when trailer connected....not useful with an off road camper!



This is where Llams is fantastic.. you can force it to +30/50 above standard or offroad height.

Note the 50km/h lowering still occurs but you are adjusting standard height to remain higher...

In conventional offroad modes with a trailer you need to push the button to get the vehicle to lift - nothing strenuous.
Grentarc
27th October 2016, 02:07 PM
What programming on the IID tool did you use to stop ride height from adjusting over 50 km. Would be also useful to stop ride height from going to standard height when trailer connected....not useful with an off road camper!

With the IID Tool you can't stop the 50 km/h speed restriction, all you do is make "Normal Height" permanently 50mm higher, whereas with Llams, it is at the flick of a switch, rather than having to have the IID Tool plugged in, then open the app, and set your height.
Both methods will do what you want, but I know with having both Llams and an IID Tool, I pick Llams for height adjustments over the IID Tool any day.