Clutch rebuild - what else to do?

[btm]

Hello All,

I am going to replace the clutch in my 2011 90 2.4 Puma and wanted to know if there are other jobs i should do whilst in there? She has done 110,000 k's and it would be good to try and address the backlash if possible? Also a mate mentioned replacing the bleed nipple on the slave cylinder because it snaps easily when trying to bleed, does that sound right or an old wives tale?

any thoughts appreciated.

cheers Tim

[big harold]

Slave cylinder and pilot bearing.
Mark

[roverrescue]

While the gearbox and t-case are on the floor

Make sure the adaptor shaft is in good nick and well lubricated
Install an Ashcroft ATB into the Tcase centre and sleeve the intermediate shaft to fix the inevitable leak

[dromader driver]

clutch arm regardless if it has been reinforced. [happycry]

[micksta1973]

Rear main seal + machine fly wheel.

[big harold]

clutch arm regardless if it has been reinforced. [happycry]
It's a Puma so it will have an inline Slave Cylinder therefore no arm to strengthen.

[Dorian]

Hello All,

and address the backlash if possible?



x 2 for the Ashcroft ATB.
Off topic, but if your chasing backlash, don't forget to check out the A-frame ball joint.

Cheers Glen

[btm]

thanks everyone for your input, Bronte is booked in next week for the job.