Removal of D pillars

[F4Phantom]

I cant remove the D pillar covers to respray. Screws all out, pulled hard to the point of not wanting to break them. Any ideas?

[TheTree]

I just used some trim removal tools to loosen the clips which hold it on

Steve

[prelude]

I got them out recently. IIRC pull at the top and slide them out upwards but I'll have a look when I get home. The old plastic does break a lot though, no matter how careful you are at times.

-P

[F4Phantom]

Ok thanks, ill try to pull upwards and see what happens.

[prelude]

Hi mate, look at the image below. You need to remove the rubber lining first, shove a breakerbar or flat piece of wood in and possible twist it to release the clips on the window end. Once you have done that just pull upwards and out.

Cheers!
-P
155591

[F4Phantom]

Hi mate, look at the image below. You need to remove the rubber lining first, shove a breakerbar or flat piece of wood in and possible twist it to release the clips on the window end. Once you have done that just pull upwards and out.

Cheers!
-P
155591

Thanks heaps thats my weekend job

[F4Phantom]

Hi mate, look at the image below. You need to remove the rubber lining first, shove a breakerbar or flat piece of wood in and possible twist it to release the clips on the window end. Once you have done that just pull upwards and out.

Cheers!
-P
155591

Thanks got them off, very tough job, got them sprayed up and looking perfect