Drilling intake manifold and tapping for boost gauge 300tdi

[Landyboy03]

Just asking if anyone has done this and recommendations cheers

[shack]

Just asking if anyone has done this and recommendations cheersThere is a bung at the back of the manifold, couldn't tell you the size or thread, but you can remove it and screw a barb in there and you are done!

[Landyboy03]

Yeah I see that there is a threaded one. There’s some sort of sensor in it and I don’t know what it’s for

[Landyboy03]

Yeah I see that there is a threaded one. There’s some sort of sensor in it and I don’t know what it’s for

https://uploads.tapatalk-cdn.com/20200119/016386468973ccf3fc969200fc69246e.jpg here’s a pic of sensor or what ever it is cheers

[Blknight.aus]

Have you got the electronic distributor build on the injector pump?

if so thats for and adjustment on the pump as part of the control system.

theres a handfull of ways of getting a boost pressure reading on a tdi depending on what you want to read. if your're after the really easy one, just put a T on the wastegate controller or put one on the line that runs the boost compensator (1/4 inch truck airline pressfit is the one you want) over on the pump side.

[Landyboy03]

Where is the boost compensator thanks

[Blknight.aus]

on the top of the injector pump

[Landyboy03]

Cheers Blknight.aus