Log in

View Full Version : Blown turbo then no start.



p38brickus
12th March 2020, 08:57 AM
Blew the right turbo on my 2008 TDV8. After it was replaced, the car will not start. Mechanic says code Crank angle sensor so that was replaced, still no go. Code says High Pressure fuel pump so that was replaced still no go. Mechanic says there is fuel TO the injectors but not from there.
Thoughts and thanks.

Graeme
12th March 2020, 11:40 AM
Assuming there are no other fault codes and that the fuel system has been bled, while cranking I suggest monitoring the crankshaft posn sensor for engine rpm, the camshaft posn sensor and the injectors for at least the other side of the engine.

theelms66
12th March 2020, 12:04 PM
Body off repair. Check wiring connections possible pin damage or ground wires not reconnected.

p38brickus
12th March 2020, 01:55 PM
Body off repair. Check wiring connections possible pin damage or ground wires not reconnected.

It wasn't body off.

p38brickus
13th March 2020, 02:17 PM
Faulty injector now diagnosed. Thoughts?

p38brickus
30th April 2020, 06:35 PM
New injector fitted but still no start. I'm just about to give up.

scarry
30th April 2020, 07:22 PM
A good Land Rover Indie is needed with the right diagnostic gear and experience to sort the vehicle.