PDA

View Full Version : Custom Made Gas Struts



gavinwibrow
16th December 2021, 11:54 AM
A few months ago there was a discussion on gas struts (for the rear door top section).

Someone mentioned a very helpful supplier (might have been in Balcatta?), but do you think I can remember where I stored the reference.

I actually want a custom made HD pair for lifting the bed in our brick after SWAMBO decided on a heavier mattress and I'm now in danger of getting a hernia each time I have to access underbed storage, or set up the HWS switch and tapwork.

Anyone recall the company?

PerthDisco
16th December 2021, 12:13 PM
Gas Struts and Gas Spring | Struts Specialist (https://www.strutspecialists.com.au/mobile/index_mobile.asp)

BradC
16th December 2021, 12:46 PM
I use these guys in Malaga : McNaughtans - Bus, Truck and Trailer Hardware (https://www.mcnaughtans.com.au/)

PerthDisco
16th December 2021, 01:31 PM
What I found out also (duh!) is as long as the strut is not dead they can recharge a strut back to working pressure. Magic!

I had some small super high pressure struts out of an 80s car sport seats which were basically unobtainium out of USA or dealer at over $150 each. There were 8 of which 7 still worked albeit low pressure and $100 later I was back in business. Handy for any odd ones although LR boot struts are off the shelf replacements.

gavinwibrow
16th December 2021, 01:39 PM
Gas Struts and Gas Spring | Struts Specialist (https://www.strutspecialists.com.au/mobile/index_mobile.asp)


Legend - many thanks