TPS 3.9 Disco

[100I]

Howdy, can a guru please tell me the voltage readings for my TPS in a hotwire 3.9 D1?
I've scoured & found a thread on a RRC which should be the same system?
http://www.aulro.com/afvb/showthread.php't=33436&highlight=tps
Here JC says 320mV - same for mine?

[4bee]

Have a bo-peep at this site.

http://www.britishv8.org/Articles/Rover-14CUX-EFI.htm

[100I]

thanks 4Bee, now I remember somone posting that link before.

[justinc]

OldZook,
I would suggest that if you set your TPS to .85v or through to 5.3V you will have some problems!

320mV is the factory spec for all hotwire 14CUX systems.


JC

[100I]

big thanks JC, thought I'd read that somewhere once, was trying to cross check it but trawling thru all these posts etc takes it out of you:o.
0.85 sounded a bit off and 5.3 might be a bit elusive...:D

Dan