View Full Version : Trouble with auto and M and S dash lights
sfako
8th February 2008, 05:00 PM
Hi i hope there is somone out there that can help me.
Steve Atkinson is my name and i live in townsville,i have a disco 2 2004 model td5 auto that i purchaced in Nov last year with 70 k on the clock.
the prob at the moment is as i back out of our drive then put the girl into drive just as i take off the dash lights M and S start flashing,The owners manual says just turn off the ignition and restart and if the lights stop there is no prob and this is the case but,,, it happens every time i start the disco and some times if it dosnt happen straight away it will within 10 mins or so with a slight shudder then the lights come on.
I have changed all oils diffs trans etc in the past 3 weeks.
I took it to the landrover dealer in townsville the only one with the test gear for a new injector loom that turned out to be a new injecter (ouch) and i asked if they would check all the codes to see if there were any other probs , the answer was none.Since then the problem has been getting worse. I have also spokent to Tim at Landrovers only and he is at a loss as is his recomended transmission guy.
I will look forward to any sugestions
Thanks Steve Ako
dmdigital
9th February 2008, 07:42 AM
Steve,
M+S flashing can be caused by a sticky linkage or dirty contact on the outside of the transmission. The A/C on the Disco's drains either side of the housing. Have a look underneath, you'll find the drain bleaders with a torch, and the check the housings connectors and external linkages for rust or corrossion.
The M+S flashing should have logged an entry in the Transmission ECU but as the owners manual says, and you have found, the faul itself will reset.
Other than that the transmision is a mistery to me.
I know its 360km away but there is a Hypertune Land Rover in Cairns with Rovacom who can also do diagnostics. Like Tim they get a good rap. Might pay to give them a call at least.
greg smith
9th February 2008, 08:07 AM
Steve I have same problem [TD5 auto 02] switch unit on side of trans sits under aircon drain!!!? definite design fault[water and electronics do not mix]Iam presently TRYING to replace the switch unit[around$350 from hypertune in Cairns--good people to deal with] the unit is easy to unbolt BUT to unplug wiring clip and joiner have fun!!! I have extended aircon drain with a piece of fuel line and a couple of zip ties, best of luck
sfako
9th February 2008, 10:06 AM
thanks guys i will dive under later today an see if your info is the prob
i will let u know
steve
sfako
9th February 2008, 05:03 PM
Wisard and Gary
I have taken the drain for the a/c out and fitted an aditional 400mm of hose so the dripping is trans to the rear along way.
Thanks for the tips and we will see if this is the prob.
I also soked the electrics with wd40
Heres hoping
Steve
sfako
9th February 2008, 05:04 PM
Sorry Wizard and Greg
2 rocks
9th February 2008, 05:17 PM
Steve
Have replied to your other thread....in Technical Chat. There can be more to this than the aircon drain.................
Mike
dmdigital
9th February 2008, 06:34 PM
Steve, I'd spray it with Lanotec once its all cleaned up. Should help seal things a little as well.
With the drains, don't make them to long or they may end up with a dead leg that doesn't drain, this will easily gum up with crud and stop the A/C draining moisture.
sfako
11th February 2008, 04:44 PM
As i said in the last post moved the drain.
Today the first start , the lights flashed but for the next 5 starts not a prob but i must say i soked the switch with wd40.
THIS must be a good thing as it is chucking down the rain at the moment and the humidity is at 90 plus. lotsa water about
will keep u all posted as to the next few days
Thanks to all for your info '
Steve
tempestv8
14th February 2008, 01:07 AM
The M&S lights appear for 3 different reasons:
1. Battery undervoltage
2. Poor earth due to loose cable or corrosion
3. Over torque due to highly chipped TD5 engine
sfako
14th February 2008, 05:43 AM
Thanks for the further input
As of the 13th only the first start is a prob an now all the rest are OK
When i first start and wait for all the dash lights to go out ,then with my foot on the brake , slip it into reverse, there is a more solid slip into gear. When this happens the lights flash, when it is just smooth it dosnt.
But i must say the prob is all but gone
HERES HOPEING Steve
greg smith
15th February 2008, 09:23 AM
Let me know how you go with all the moisture repellant gear. I hav'nt replaced the switch in mine as yet
sfako
17th February 2008, 08:15 AM
Hi Guys
Just a quick note to say that all the light flashing has gone.
Thank you to all that replied your info guided me to a shortcut for solving the issues with my girl.
My wife and i will be leaving Townsville with our caravan heading eventualy to the West via Adeliade at the end of this month and having contact through AULRO is yet another string in our support bow,
so thanks
Steve and Linda Atkinson
sfako
18th February 2008, 04:40 PM
:) All is now ok and we are running fine.
the a/c water was the problem
Thanks to all for your input
Steve
Powered by vBulletin® Version 4.2.4 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.