PDA

View Full Version : 130...braking effects indicator ??


lardy
26th December 2008, 12:20 PM
I think i have an earth issue with the 130 when i use the right turn signal indicator i get a increase in speed of the indicator whilst under braking any experience of this anyone ????? thanks andy
lardy
29th December 2008, 06:56 PM
you should try looking at the connectors on the indicators to loom section, ensure they are not corroded making a poor earth.
If it turns out to be the case just change them out for new parts.
i hope that helps lardy !
lardy
29th December 2008, 06:57 PM
thanks mate,
I did what you suggested, and sure enough it was a connector that had corroded, i changed it out and what do you know it works fine thanks for your input lardy
Col.Coleman
29th December 2008, 07:13 PM
That's not your only problem.

You've started talking to yourself.

And even worse your getting answers:eek:

CC
weeds
29th December 2008, 07:49 PM
That's not your only problem.

You've started talking to yourself.

And even worse your getting answers:eek:

CC

:D:D:D
tazd
29th December 2008, 07:59 PM
when i flick my indicator the trailer symbol flashes aswell???? any ideas? or same as above
weeds
29th December 2008, 08:11 PM
when i flick my indicator the trailer symbol flashes aswell???? any ideas? or same as above

if you have indicators fitted to you bullbar than this will do it.....the extra load on the circuit makes it think there is a trailer fitted

lower wattage bulbs fixes the problem from memory
BilboBoggles
29th December 2008, 08:12 PM
I believe it's supposed to flash once when the indicators are first used, if it continues to flash then the load on the indicator circuit is too high and the indicator relay thinks the trailer is connected. I had this in mine when I had a 20W indicator globe in the bull bar instead of 5W.
abaddonxi
29th December 2008, 08:13 PM
Sorted.

Glad we could be of assistance.

:D

Cheers
Simon
lardy
6th January 2009, 11:16 PM
I believe it's supposed to flash once when the indicators are first used, if it continues to flash then the load on the indicator circuit is too high and the indicator relay thinks the trailer is connected. I had this in mine when I had a 20W indicator globe in the bull bar instead of 5W.

this is the same as my disco commercial and subsequent disco and defender flash once in sequence with indicator then cease