View Full Version : Air Intake Grille
scanfor
16th February 2009, 10:02 PM
Some little Herbert with a screwdriver decided to lever off the fresh air intake grille on the RH wing (300Tdi) while I was parked.
The little black clips broke off and are still in the bodywork. Does anyone have any tricks or tips for getting them out please?
I hope that I can get a replacement part relatively quickly, but would it cause any damage to drive around without it for a day or so?
Regards
Scott
THE BOOGER
16th February 2009, 11:24 PM
Should be ok grill is there for looks and to stop branches getting into air filter or is it your heater inlet either way its not a great problem.:)
JamesH
18th February 2009, 09:45 AM
Did I read somewhere you can get steel ones? Mine has broken either overtightened, old, received a knock or all of the above.
scanfor
18th February 2009, 06:41 PM
yes, I think i saw s/s grilles at MR in Redcliffe - might look a bit naff on the Defender though methinks.:eek:
Scott
aew849
20th February 2009, 06:45 PM
Sounds like a ripper of an excuse to fit a snorkel instead of playing around with a replacement grill.
aew849
2004 130 DCPU - "Bev"
Vin Rouge
20th February 2009, 07:03 PM
I've just fitted a snorkel to my Defender so if you want the old grille, you're welcome to it.  You don't say where you are, but I'm in Brisbane
scanfor
21st February 2009, 01:16 PM
Vin
Thanks for the offer, I´m in Cleveland, but I would be happy to travel to pick it up from you.
I did contemplate the snorkel option, but I just can´t bring myself to spend $400 on a bit of blow-moulded plastic yet - maybe one day.
Thanks again
Scott
Jock The Rock
21st February 2009, 01:24 PM
Hey mate
If you still had the clips in your bodywork, have a look here. Some photos of when I did my snorkel
http://www.aulro.com/afvb/projects-tutorials/69051-fitting-snorkel-300-tdi-defender.html
Just push the centres out (push in towards the engine bay)
p38arover
21st February 2009, 01:45 PM
Some little Herbert with a screwdriver decided to lever off the fresh air intake grille on the RH wing (300Tdi) while I was parked.
Should be ok grill is there for looks and to stop branches getting into air filter or is it your heater inlet either way its not a great problem.:)
As Booger asks, is it your cabin air intake or the engine air intake?
scanfor
21st February 2009, 04:42 PM
Ron
It's the engine air intake - Jock's piccys are right on the money - good tip about the centres just pushing through too thanks.
Regards
Scott
Powered by vBulletin® Version 4.2.4 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.