dmdigital
13th June 2009, 02:44 PM
This one I've loosely cable tied up as the smaller hose was rubbing against the power steering reservoir. You can see I've also repositioned the rubber block to move the larger hose off the same reservoir. https://www.aulro.com/afvb/images/imported/2009/06/886.jpg
In this case (just back from the one above) the clamp was rubbing on the lower hose as it was positioned outside of the cloth abrasive sleeving. I moved the block back and the clamp forward.
https://www.aulro.com/afvb/images/imported/2009/06/887.jpg
Wire under the new conduit I tied up to the bracket. It was sitting against the air-conditioning bleed block.
https://www.aulro.com/afvb/images/imported/2009/06/888.jpg
This pipe I sleeved very early on, think it's been mentioned before as an issue.
https://www.aulro.com/afvb/images/imported/2009/06/889.jpg
I'm a bit worried about this wiring block, but at present can't seem to work out a suitable way to move it away from the other stuff.
https://www.aulro.com/afvb/images/imported/2009/06/890.jpg
https://www.aulro.com/afvb/images/imported/2009/06/891.jpg
This conduit now covers the coolant line that rubs against a bolt head on the edge of the guard. Also in this picture you can see a small rub mark starting on the brake fluid reservoir.
https://www.aulro.com/afvb/images/imported/2009/06/892.jpg
Lastly my take on remedying the rubbing brake fluid reservoir until I can get to the dealer in 3 weeks time (and about 4000km).
https://www.aulro.com/afvb/images/imported/2009/06/893.jpg
Haven't done underneath the vehicle yet, so I'll post up anything more I find.
In this case (just back from the one above) the clamp was rubbing on the lower hose as it was positioned outside of the cloth abrasive sleeving. I moved the block back and the clamp forward.
https://www.aulro.com/afvb/images/imported/2009/06/887.jpg
Wire under the new conduit I tied up to the bracket. It was sitting against the air-conditioning bleed block.
https://www.aulro.com/afvb/images/imported/2009/06/888.jpg
This pipe I sleeved very early on, think it's been mentioned before as an issue.
https://www.aulro.com/afvb/images/imported/2009/06/889.jpg
I'm a bit worried about this wiring block, but at present can't seem to work out a suitable way to move it away from the other stuff.
https://www.aulro.com/afvb/images/imported/2009/06/890.jpg
https://www.aulro.com/afvb/images/imported/2009/06/891.jpg
This conduit now covers the coolant line that rubs against a bolt head on the edge of the guard. Also in this picture you can see a small rub mark starting on the brake fluid reservoir.
https://www.aulro.com/afvb/images/imported/2009/06/892.jpg
Lastly my take on remedying the rubbing brake fluid reservoir until I can get to the dealer in 3 weeks time (and about 4000km).
https://www.aulro.com/afvb/images/imported/2009/06/893.jpg
Haven't done underneath the vehicle yet, so I'll post up anything more I find.