Thread: 40mm Body Lift RRC

There is more to a body lift than the 10 blocks.

There is a support under the trans tunnel (as standard just a piece of rubber) and the supports over the rear wheel arch (2 each side) and the radiator supports. Crawl under and have a look at anywhere the body touches the chassis.

Here is a cheaper kit (I have no affiliation with the supplier, just spied it on ebay) Landrover Discovery 1 Range Rover 2 Inch Body Lift KIT in Burleigh Waters, QLD | eBay

Neale

Originally Posted by Corgie Carrier

There is more to a body lift than the 10 blocks.

There is a support under the trans tunnel (as standard just a piece of rubber) and the supports over the rear wheel arch (2 each side) and the radiator supports. Crawl under and have a look at anywhere the body touches the chassis.

Here is a cheaper kit (I have no affiliation with the supplier, just spied it on ebay) Landrover Discovery 1 Range Rover 2 Inch Body Lift KIT in Burleigh Waters, QLD | eBay

Neale

I've also noticed this one. It is almost the same as the LRA one with a few of the lateral supports missing and no bullbar lift. I only need to go up 40mm, the LRA one is 2.5" and this one is 2". I guess I could live with the 10mm.

For the transmission support and the support above the rear wheel, the rubber ones, I was planning on spacing it with 40mm box section and refitting the rubber.

The LRA ones are only 2" now, they stopped making the 2.5" about 18 mths ago.

Good luck with the lift, it makes the truck look really big :-)

I have a LRA 2.5" kit in my disco 1.

Neale