Thread: Fitting a towing hitch

What brand Arthur? Genuine LR (I recently acquired one) also have plates that are used in conjunction with washers and bolts.

I was lucky enough to get the lot..........with original bolts. Can PM you a pic if you want.

Cheers, DL

Originally Posted by 350RRC

What brand Arthur? Genuine LR (I recently acquired one) also have plates that are used in conjunction with washers and bolts.

I was lucky enough to get the lot..........with original bolts. Can PM you a pic if you want.

Cheers, DL

Thanks mate, it is the same hitch used on Disco 1

From the one (unknown brand) that I pulled from my RRC to fit an ARB rear bar. 4 off 1/2" x 4" UNC and 2 off 7/16" x 4 3/4" UNC.

This are the 2 bolt sizes that I need.
I got the others in place holding the gas tanks where was the fuel tank.

Ok, that's a bit different to mine. The one I removed (and is now fitted to my D1) had 4 x bolts along the back. RRC bolt size was 1/2"UNC, but from memory the D1 was 3/8" or 7/16", still around that 4" long mark tho. Have a funny feeling I may have trimmed them a tad for the D1 tho.