Thread: Roof Console Fitment?

Looks like a hand made console Razzor


There are ribs under that roof lining
Where the interior lights are .... Take the plastic lens out .. undo the screws holding the light in and you will see it

It goes in a left / right direction .... (handgrip handle on roof to the other handgrip handle on driver side)



Also you will find another rib following the top of the windscreen

Undo all the sunvisor & mirror screws to drop a section the hood lining down to find it

Mike

I found these photo's compliments of Walker

You can Just see a rib that runs along the very front just behind the windscreen and Im pretty sure there is one where the interior light is from memory of seeing a bare roof at my mates workshop.

\

Awesome, Thank you guys for the info. Now I know what to look for

I am guessing the ribs sit a little lower then the actual roof & you screw / rivet in to these?

hope these help

thanks mate!! That's even better!!

So now all I have to decide is how to get the rails up there nice & tight & so they don't come loose.

So.... what would you guys do>? Rivet? Self taped screws? House mate reckons rivet & use something to stop it rattling like bodydeadner

Here ya go mate.

First pic is the mirror mount and the upper windscreen bar where you can screw or pop rivet your console to. Those holes are for the roof mounting screws.



And this is the roof brace above the interior light, it is about 1inch from the roof so use short screws or pop rivets to mount the console.

Beatin to it by pomonastik.

I went and took some photos and uploaded them, but didn't reload this page to check for updates before posting, anyway now you got two sets of picks.

Thats just awesome Thanks a million guys.

I'll put up pics when screwed / riveted in