The Gwyn Lewis Way link....
[ame]http://www.gwynlewis4x4.co.uk/wp-content/uploads/2014/05/Spring-Height-Measurments.pdf[/ame]
Printable View
The Gwyn Lewis Way link....
[ame]http://www.gwynlewis4x4.co.uk/wp-content/uploads/2014/05/Spring-Height-Measurments.pdf[/ame]
That works out about right
front measures 28.5 cm
rears 33cm
looking at going with an Aussie Ryder setup
The Ultimate Suspension : Custom Built Suspension for all Vehicles
with RFR-13HD front springs (mine has a winch so needs the extra LBA capacity)
I'm just tossing up what springs to put on the back.
Standard or matching HD with the front.
I wouldn't mind a softer ride on the rear and I'm never going to load it to the hilt or tow too much, but I wonder if that will give it a strange ride having some pretty stiff springs in the front and softer ones in the back.
Those are some sagged springs mate! Mine measure 300mm and 350mm.Quote:
Originally Posted by Chris078
I stand by my earlier post in this thread :)
huh. and I thought it was a PITA to get in and out of now, let alone another cm higher.
The setup I'm going with is supposed to be 30-50mm up from the stock 110 height. Hopefully that should be about what it is now. I really don't want it any higher.
what did you end up putting in yours?
Its all in the hop whilst hold the steering wheel. Also remove your canvas seat covers, that will make it easier to slide out ;)Quote:
Originally Posted by Chris078
You don't really want to go lower then stock Perentie height because you will limit your suspension travel as they have extended bump stops from factory.
My springs are still on the VERY long shopping list.