Thread: electronic brake controller

Without looking, I would say yes as there is only 4 wires on the controller.

Black +ve
White -ve
Red Brake ligt wire pick-up
Blue Variable voltage feed to pin No.5

I have fitted a RedArc remote head to my vehicle also, very good unit & simple to use.

Cheers

I just installed a Tekonsha P3 and yes the wiring and colours seem exactly the same.

The Redarc has the advantage of low footprint, as it is a remote control design. However I have heard it is not good as the Tekonsha P3 in the way it works.

refer here :
http://caravanersforum.com/viewtopic.php?f=2&t=5567

I like the diagnostics displays of the P3, even gives you battery volts.

x2 for the P3.

I had a Voyager and now a P3. Much prefer the P3, easy to setup and yeah the voltage display shows exactly whats going on. It seems very smooth on the take up too, i don't know if the P3 is pendulum based but whatever they have done with it works well.

Cheers

+ one for the red arc, I just installed one in the d2 using the wiring from the previous owners prodigy, it doesn't intrude and it works perfectly.

X3 for the p3

I was going to install the redarc but after reading lots of info went with the P3.
Definately the same wiring. Only wire size may vary. I think that the redarc uses smaller gauge wiring. though so you should be fine as your existing should be this or greater.

ps. cant remember the required gauges tho