cut the cable at the plug for radio end and one you have it in place bring it up here and i will solder it up for you![]()
I have removed a cactus 27Mhz set from my ute, which was bolted to the rear of the cubby box. For the moment I intend to fit the UHF there, until I can sort an overhead console.
At the moment there is a small hole drilled un the metal plate underneath the console, which has the power cord running through it. This hole previouslyu had the CB aerial cable as well (I had to cut the plug off to get it out).
Given that the UHF cable I have is fully assembled... where would be the best place to run it ? Should I drill the exusting how out (would need to be a lot bigger in order to allow the plug the pass thorugh).
Any and all USEFUL advice appreciated.
It's not broken. It's "Carbon Neutral".
gone
1993 Defender 110 ute "Doris"
1994 Range Rover Vogue LSE "The Luxo-Barge"
1994 Defender 130 HCPU "Rolly"
1996 Discovery 1
current
1995 Defender 130 HCPU and Suzuki GSX1400
cut the cable at the plug for radio end and one you have it in place bring it up here and i will solder it up for you![]()
2007 Discovery 3 SE7 TDV6 2.7
2012 SZ Territory TX 2.7 TDCi
"Make the lie big, make it simple, keep saying it, and eventually they will believe it." -- a warning from Adolf Hitler
"If you don't have a sense of humour, you probably don't have any sense at all!" -- a wise observation by someone else
'If everyone colludes in believing that war is the norm, nobody will recognize the imperative of peace." -- Anne Deveson
“What you leave behind is not what is engraved in stone monuments, but what is woven into the lives of others.” - Pericles
"We can ignore reality, but we cannot ignore the consequences of ignoring reality.” – Ayn Rand
"The happiness of your life depends upon the quality of your thoughts." Marcus Aurelius
cut it and goto jaycar and buy a screwdown connector use that till you can get it soldered up properly OR like Ive done keep forgeting about it cause its still working properly.
Dave
"In a Landrover the other vehicle is your crumple zone."
For spelling call Rogets, for mechanicing call me.
Fozzy, 2.25D SIII Ex DCA Ute
TdiautoManual d1 (gave it to the Mupion)
Archaeoptersix 1990 6x6 dual cab(This things staying)
If you've benefited from one or more of my posts please remember, your taxes paid for my skill sets, I'm just trying to make sure you get your monies worth.
If you think you're in front on the deal, pay it forwards.
Ok so I ran it and it was all working fine until....
I went to Carlovers and managed to snap the antenna (or rather the base of the antenna which seems to be a seperate bit but is, of course, not apparently availble seperately) off with the hose thingy. Sigh. A new one (with a spring base) is apparently about $130ish and has a different cable (attached to antenna) so I;d have to run one... again !
Anyone have a spare UHF antenna that goes straight onto the standard GME type antenna socket at the bullbar ?
Advice ?
It's not broken. It's "Carbon Neutral".
gone
1993 Defender 110 ute "Doris"
1994 Range Rover Vogue LSE "The Luxo-Barge"
1994 Defender 130 HCPU "Rolly"
1996 Discovery 1
current
1995 Defender 130 HCPU and Suzuki GSX1400
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks