Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 24

Thread: Modern Equivalent of "Vintage" Radio

  1. #11
    BradC is offline Super Moderator
    No one of consequence
    Supporter
    Join Date
    Mar 2018
    Location
    Perth (near Malaga)
    Posts
    3,546
    Total Downloaded
    0
    Quote Originally Posted by Graeme View Post
    Beware of exploding electrolytic capacitors in old radios when powered, especially any in the power supply circuit of 240V equipment.
    I had an old valve tech give me this trick for bringing an old device back into service.

    Remove all valves except the rectifier (if it has one). Put a ~40W bulb in series with the mains cord to form a non-ohmic current limiter. Switch on.
    If the electros are duff the bulb will light brightly, then over a couple of hours as they "reform" it'll gradually dim until it's effectively out. There may be a detectable glow from the heater current of the rectifier valve (if it has one). At that point you can power down, wait for the HV capacitors to discharge (or discharge them gently) and put the valves back in.

    That generally prevents them from exploding in a (usually) spectacular fashion.
    MY08 D3 - The Antichrist - "Permagrimace". Turn the key and play the "will it get me home again" lottery.

  2. #12
    JDNSW's Avatar
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    Quote Originally Posted by Lionelgee View Post
    Hello John,
    ........
    Hang on wooo wooo some brain cells are sparking I am hearing the name 'Mandrake'? woo woo.

    Or was that a serialised cartoon in the now long defunct local newspaper? .........


    Kind regards
    Lionel
    I am pretty certain it was both - but that was a long time ago.....
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  3. #13
    Join Date
    Mar 2010
    Location
    Queensland
    Posts
    4,125
    Total Downloaded
    12.97 MB
    Quote Originally Posted by JDNSW View Post
    I am pretty certain it was both - but that was a long time ago.....
    G'day John,

    Thank you for your post. I went on a bit of a hunt online. I found this link Australian radio series (1930s–1970s) - National Film and Sound Archive accessed 18th of September 2023 from
    https://www.nfsa.gov.au/sites/defaul...on_amended.pdf

    It amounts to 244 pages of goodness. No I could not find Mandrake in this Australian publication. However, I did find it here though accessed from Mandrake the Magician | Old Time Radio. Plus here ... Mandrake The Magician 401111 001 First Episode, Old Time Radio - YouTube

    Perhaps it was not Mandrake on the radio that I did hear back then. I will have a closer look at the contents of the 244 pages later on to see if I can narrow it down a bit. Perhaps it was a Raymond Chandler or similar detective? It was a fair while ago that I sat down and listened to it.

    Some time later .....

    There are 15 results for the word 'detective' within the Australian National Film and Sound Archive publication. With a brief check one of these results is no less than 'Philip Marlowe'.

    Kind regards
    Lionel

  4. #14
    Join Date
    Apr 2012
    Location
    Whyalla, SA
    Posts
    7,545
    Total Downloaded
    0

    Modern Equivalent of "Vintage" Radio

    Quote Originally Posted by Lionelgee View Post
    G'day Tombie,

    Thank you for your suggestion Tombie. This option is no doubt far superior than my radio was even in its heyday. However, a computer version of a radio is like an ebook version of a hardcopy book. One has the ability for you to hold it in your hands and physically turn the pages over. Feel its weight and if it is an older book, smell its bouquet. See its foxed edges. You know the whole multi-sensory experience of a real book. All this stuff translates to the difference between a version of a streaming computer service and a radio with analogue features. Hmmm, you might know the answer already to what style of watch I wear and what style of clocks hang on different walls in my house.

    Yep - call me 'old fashioned'. I can live with it Tombie. It might also just explain my interest in Series Land Rovers. My interest in Land Rovers in general finishes at the D1 Discovery and the 110 Defender. Being the opinionated sod that I am - these were the real Land Rovers. Oh I do include the Perenties as being real Land Rovers too. Yes, the Td5 in the D2 was a Land Rover developed motor. After these models the vehicles became too highly dependent upon electronics. They also suffered from other car manufacturer's - who became new owners - influences. Remember the bit about my being an opinionated sod ... :0) Ummm ... think ... think ... I can live with that too... :0)

    Kind regards
    Lionel
    All good Lionel Modern Equivalent of "Vintage" Radio

    I run an analogue face on my Apple Watch,
    I have analogue clocks on my walls and digital Amazon screens throughout the house.
    I prefer paper workshop manuals to online ones where practicable.
    I like high tech vehicles and enjoy simple machinery as well.
    I do all my own mechanical, electrical and electronic repairs.

    I don’t own vinyl, cds, dvds or video cassettes anymore,
    I don’t have a tv antenna on my home,
    I don’t play online games,
    I stream everything, Audio and Visual
    I use a laptop for shopping, work and CAD only,

    And my Mountain bike has a computer and motor assist….

    I prefer live music to all other options

    I’m struck between both… Modern Equivalent of "Vintage" Radio

    Take care, hope you can find a suitable replacement for your receiver.

  5. #15
    Join Date
    May 2017
    Location
    N/A
    Posts
    2,661
    Total Downloaded
    0
    Quote Originally Posted by Lionelgee View Post
    Hello All,

    Could some of you radio enthusiasts let me know what a modern equivalent of the following radio would be?

    ......

    One of the things I used to really enjoy about Phillips D2603 was it having dials that needed to be manually turned. So when you learned radio enthusiasts start making recommendations could you please consider radios with the now old fashioned dials that need to be physically turned. Not the modern digital tuner type of stuff. You know the supposedly 'smart' and more 'convenient' automatic tuning features.

    Kind regards
    Lionel

    There's any number of specifically retro-styled radios:

    Explore Our Range | Roberts Radio

    Roberts Rambler Range | Retro Radios | Roberts Radio

    CP-100 AM / FM / Bluetooth / AUX│SANGEAN Electronics


    Radios with dials:

    Shop All – Tivoli Audio AU

    In my experience these electronic dials work better than one radio I had as a kid where the knob was connected to the actual tuner by an elastic band ...


    Modern multi-wave radios:

    ATS-909X2 FM/SW/MW/LW/Air Receiver│SANGEAN Electronics

    https://www.aussiestormshop.com.au/p...craft-channels

    There's still a wide range of this kind of radio sold in Japan.
    Arapiles
    2014 D4 HSE

  6. #16
    Join Date
    Jan 1970
    Location
    Adelaide Hills. South Australia
    Posts
    13,349
    Total Downloaded
    0
    Quote Originally Posted by Lionelgee View Post
    Hello All,

    Could some of you radio enthusiasts let me know what a modern equivalent of the following radio would be?

    When I turned 21 years of age I used some of my birthday money to buy the following radio... The one that is now considered to be a 'vintage' radio!!!!


    Phillips D2603 (1982) | 4 Band Receiver | 2 Loudspeakers

    I even found a youTube clip on the internet of the same radio that is part of an enthusiast's collection... accessed 18th of September 2023 from, PHILIPS D2603 (1982) | 4 Band Receiver | 2 Loudspeakers - YouTube

    To make things a bit easier for you to base an informed decision off here are the radio's technical specifications.. available from the Radio 'Museum' of all places ... accessed 18th of September 2023 from, D2603 /00 /02 Radio Philips Hong Kong, build 1982 ?, 22 pictures | Radiomuseum

    Unfortunately along the processes of getting married and having children it that meant the poor old radio got forgotten. When I did stumble across it I found that the batteries has leaked acid. Subsequently, the plastic base of the radio case was fused to a shelf in my old less than waterproof old shed. Prior to getting married that radio was my only link to the outside world when I lived in a caravan park at Queen Mary Falls in Queensland. I spent hours tuning into overseas broadcasts and I really enjoyed it.

    My wife and I have been empty-nester's for some years now, and I finished my studies last year. This means that I have some of that stuff called 'spare time' on my hands. I would like to be able to tune in again to overseas broadcasts. My poor old Phillips D2603 radio stayed on the same shelf in the same less than waterproof shed that I broke it free from probably a couple of decades ago now. So, even without considering its lack of a base to its case, the whole radio's condition can only be described as 'very sad'. Not something another party I cohabit with might consider being suitable for being located inside the house.

    One of the things I used to really enjoy about Phillips D2603 was it having dials that needed to be manually turned. So when you learned radio enthusiasts start making recommendations could you please consider radios with the now old fashioned dials that need to be physically turned. Not the modern digital tuner type of stuff. You know the supposedly 'smart' and more 'convenient' automatic tuning features.

    Yes - I can be a demanding sort of sod - sometimes. By the way, at the time I discovered the state of the radio I played safe and did not hook the set up to 240 volts. Just out of interest, I am off to track down some D-Cell batteries to check to see if the old radio still works.

    Kind regards
    Lionel
    Re the Station Selector, I recall that in my experience the Tuner was attached to the knob via an Elastic BAND "type" of belt & that in turn rotated the Tuner. You may have already checked this but worth looking at.
    All those years on it would be a miracle if said belt if fitted it wouldn't be be in one piece or even capable of gripping it's "pullies"

    Good luck with getting it mobile again Lionel, it doesn't deserve the misc junk skip yet.

    Hope this helps.

  7. #17
    JDNSW's Avatar
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    Also relevant to this thread, I was at an auction on Sunday. One of the lots sold, which I did not bid on, included amongst a lot of other stuff, a cardboard box containing the remains of a home made crystal set, built on a wooden baseboard with a front panel cut from a plywood butterbox - as shown by the printing on it. It was similar to the one me and my brother built in the 1940s.
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  8. #18
    Join Date
    Mar 2010
    Location
    Queensland
    Posts
    4,125
    Total Downloaded
    12.97 MB
    Quote Originally Posted by JDNSW View Post
    Also relevant to this thread, I was at an auction on Sunday. One of the lots sold, which I did not bid on, included amongst a lot of other stuff, a cardboard box containing the remains of a home made crystal set, built on a wooden baseboard with a front panel cut from a plywood butterbox - as shown by the printing on it. It was similar to the one me and my brother built in the 1940s.
    Hello John,

    Very relevant John. I think it was a rite of passage for males to experiment with crystal radio sets in their youth. This included my first decade of life being the 1960s. I helped my older brother - okay looking back with the benefit of hindsight - I probably hinder my brother with his interest in crystal radios. My elder brother was born in the late 1950s. Years later at a time when I still had not found my vocational niche, I was working as a Trades Assistant and the local electronics electrical appliance repair shop. My shop manager was a radio nut. He mentioned that at the time - the mid-1980s, there were international competitions where different radio enthusiasts competed in building crystal radio sets. The winners produced sets that had the greatest range of reception and the best sound quality. All this had to be done within the guidelines of using components traditionally associated with building crystal radio set. No, I did not become one of these crystal radio enthusiasts.

    Kind regards
    Lionel

  9. #19
    Join Date
    Jul 2012
    Location
    Hobart Tasmania
    Posts
    231
    Total Downloaded
    0
    Hi Lionel et. al.

    When I think of my first crystal set I made 60+ years ago a diode with the number BC108 comes to mind. Am I correct?

    Listening to the radio on Sunday nights in Hobart, the two detective shows I remember were "Spiral Ten" and "Hunt The Man Down", the latter having very scary theme music. Anyone else remember them?

    Peter

  10. #20
    Join Date
    Mar 2010
    Location
    Queensland
    Posts
    4,125
    Total Downloaded
    12.97 MB
    Quote Originally Posted by TasD90 View Post
    Hi Lionel et. al.

    When I think of my first crystal set I made 60+ years ago a diode with the number BC108 comes to mind. Am I correct?

    Listening to the radio on Sunday nights in Hobart, the two detective shows I remember were "Spiral Ten" and "Hunt The Man Down", the latter having very scary theme music. Anyone else remember them?

    Peter
    Hello Peter,

    I cannot recall much of the components in the crystal radio set that I was hindering my elder bother with. I went online and found this link ... Accessed 20th September 2023 from, How to make a batteryless (crystal set) radio - BuildCircuit.COM. It includes a parts list and circuit diagram. From memory the international crystal radio competitions required the competitor to build as much of the components by hand from things like a roll of copper wire. A core that they made themselves so they could wrap the wire around it. So not a case of buying a set of off the shelf components.

    Kind regards
    Lionel

Page 2 of 3 FirstFirst 123 LastLast

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!