Results 1 to 4 of 4

Thread: best way to remove wheel arch liner?

  1. 22nd May 2010, 09:53 PM #1
    fev Guest

    best way to remove wheel arch liner?

    Hey guys, I've searched the web and looked on loads of landy forums but to no avail. Can anyone tell me how to remove the passenger side wing on my 94 disco? I think I know where all the screws/bolts are located but how do I get the plastic cover off in the wheel arch (and not damage the clips as I really would want to put it back on


    Thanks
    Reply With Quote Reply With Quote
  2. 22nd May 2010, 10:47 PM #2
    Landover's Avatar
    Landover
    Landover is offline Wizard Supporter
    Join Date
    Aug 2009
    Location
    Sunbury Victoria
    Posts
    1,133
    Total Downloaded
    0
    I used a small flat blade screw driver and some side cutters to remove them. You work the middle pin out a bit then get cutter or pointy nose pliers under them and pull it out, then the clip should release. Give a bit of a pull and flex and should come away. The bolts and screws are pretty easy to find to remove the wing, just look around it.
    Cheers, David.
    My Land Rover has made me a better Mechanic........
    D2 TD5 Manual, CDL, Detroit Rear, Truetac Front, 2" OME lift, 32" MT Tyres, ARB Bull Bar, Winch, TJM Roof Rack, Driving Lights, Dual Batteries, ARB Side Steps, Rear Draws, Uhf.
    Reply With Quote Reply With Quote
  3. 23rd May 2010, 10:06 AM #3
    ade's Avatar
    ade
    ade is offline Master
    Join Date
    Jan 2010
    Location
    tom price the pilbra, west aust
    Posts
    680
    Total Downloaded
    0
    king kcrome seel a set of proper trim rtemoval tools.
    makes life so much easier and saves breaking all the fiddly little bits with screw drivers or pliers
    Reply With Quote Reply With Quote
  4. 23rd May 2010, 10:06 AM #4
    Tank's Avatar
    Tank
    Tank is offline AT REST
    Join Date
    Jan 1970
    Location
    Moruya Heads/Sth. Coast, NSW
    Posts
    6,532
    Total Downloaded
    0
    As Landover says, but I use my electrical crimping/cutting/stripping tool as it has a very thin flat surface to get in behind the head of the centre clip, there are 3 or 4 bolts at the door end of the guard which you get at with the front doors open, Regards Frank.
    Reply With Quote Reply With Quote
« Has any one built drawers and bed platform in Disco1 | diff-lock selector problems »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!