Thread: Discovery 1 door handles same as Range Rover?

And the same as some sort of morris I think.

Yes but the disco ones are black, not shiny, and they are off the Morris Marina.

I have a black Disco one on my drivers door of the Sherwood. It looks good actually I am considering changing them all, as I have a 'few' Disco doors lying about

JC

Mine has issues opening the drivers door, anyone have instructions on how to adjust it? Think it just doesn't pull on release mech so I have to jiggle it to open the door

Originally Posted by fev

Mine has issues opening the drivers door, anyone have instructions on how to adjust it? Think it just doesn't pull on release mech so I have to jiggle it to open the door

Remove door trim, the rod from the handle down to the latch needs shortening, usually by about 3 or 4 mm max. It is threaded at the bottom end so just unclip it from the plastic clip at the top (Handle) end and you can then rotate it to shorten, then reclip it in.

JC

I seem to remember there's a plastic rod (white) behind there that pushes in some way and can flex quite a bit. Replacing it with a piece of bolt.

Originally Posted by clubagreenie

I seem to remember there's a plastic rod (white) behind there that pushes in some way and can flex quite a bit. Replacing it with a piece of bolt.

Certainly flexes a lot more when moving out further, gets better after the rod is shortened. Also, a blob of grease on the end of it helps too, lowers the friction.

JC

Thanks guys

Just fit D2 doors?