Results 1 to 4 of 4

Thread: 200 tdi crank bolt

  1. 9th February 2012, 02:42 PM #1
    123rover50's Avatar
    123rover50
    123rover50 is offline YarnMaster Supporter
    Join Date
    Jun 2009
    Location
    Queensland
    Posts
    3,442
    Total Downloaded
    0

    200 tdi crank bolt

    My torque wrench only goes to 150 ft/lbs.
    I need 250 ft/lbs. Can I go the same as a 300 and do it to 59 ft/lbs and angle tighten 90 deg or just get a long bar and swing on it?
    Didiman
    Reply With Quote Reply With Quote
  2. 9th February 2012, 03:33 PM #2
    bee utey's Avatar
    bee utey
    bee utey is offline AT REST
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    Calculate it. Pounds force multiplied by feet of lever length. 4 feet and 62 lb or 28kg.
    Reply With Quote Reply With Quote
  3. 9th February 2012, 06:34 PM #3
    Tank's Avatar
    Tank
    Tank is offline AT REST
    Join Date
    Jan 1970
    Location
    Moruya Heads/Sth. Coast, NSW
    Posts
    6,532
    Total Downloaded
    0
    See if you can buy/borrow a Torque multiplier, Regards Frank.
    Reply With Quote Reply With Quote
  4. 9th February 2012, 08:49 PM #4
    123rover50's Avatar
    123rover50
    123rover50 is offline YarnMaster Supporter
    Join Date
    Jun 2009
    Location
    Queensland
    Posts
    3,442
    Total Downloaded
    0
    Thanks blokes. I didnt fancy hanging my spring balance off a 4 ft pole and thought the 300 method may carry over. Never mind,, I will just swing on it.
    Reply With Quote Reply With Quote
« Oversize Exhaust for TDi 300 | Rear steel bumper »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!