Results 1 to 3 of 3

Thread: Transfer case bolts

  1. 31st August 2014, 02:52 PM #1
    7knightsfishing
    7knightsfishing is offline Fossicker
    Join Date
    Jun 2014
    Location
    Floraville 2280
    Posts
    19
    Total Downloaded
    0

    Transfer case bolts

    About to put my LT230 back in.
    Not sure where the different length bolts go because I did not mark them.
    Help please.
    Reply With Quote Reply With Quote
  2. 31st August 2014, 03:57 PM #2
    bee utey's Avatar
    bee utey
    bee utey is offline AT REST
    Join Date
    Apr 2009
    Location
    Crafers West South Australia
    Posts
    11,732
    Total Downloaded
    0
    It's not exactly hard to work out. Any bolt screwed into an alloy casting should engage to a thread depth of around 2 to 3 times the bolt diameter. If any of the 10mm bolts you install has more than 30mm or less than 20mm of shank exposed before engaging the thread they are likely in the wrong holes. You can also measure the depth of threaded holes with a rod of some sort to double check. From memory there's only one hole where you can foul a gear with a too long bolt, somewhere down the middle, screwed in from the front.
    Reply With Quote Reply With Quote
  3. 31st August 2014, 07:01 PM #3
    7knightsfishing
    7knightsfishing is offline Fossicker
    Join Date
    Jun 2014
    Location
    Floraville 2280
    Posts
    19
    Total Downloaded
    0
    Thanks mate. Had already done exactly what you said and any bolt will fit any hole even allowing for the overall length and length of shank. Yes, the 2 threaded into the transfer go right through which also means sealing the threads. They will be getting the shorter bolts.
    Reply With Quote Reply With Quote
« NEW CAR!! | Handbrake adjuster »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!