Thread: Sliders/Side Steps

Originally Posted by Grover-98

Too weigh up the costs compared to amount of effort, how much would i expect to pay for a slider like THAT KIDS?

I want the tube step style and slider. I looked on Cheezy racing and they were retailed at $795

Cheers guys.

Hi Grover-98,
I think if you are doing it to save money then probably forget about it..... I looking at doing it for the challenge and the satisfaction of a job well done....

Cheers

Hmmm Ray needs a MIG

And here.

http://www.aulro.com/afvb/technical-...thwhile-3.html

Grover

Im not sure but Discowhite used to make them for people and there alot cheaper than cheezy racing

Originally Posted by DISCOBEAR

Hi Grover-98,
I think if you are doing it to save money then probably forget about it..... I looking at doing it for the challenge and the satisfaction of a job well done....

Cheers

why wouldnt you want to save money these days??
theres no way the steel in a pair of sliders adds up to $800.

cheers phil

Originally Posted by discowhite

why wouldnt you want to save money these days??
theres no way the steel in a pair of sliders adds up to $800.

cheers phil

x2...

OK I made a set of Discowhite design sliders got the steel from Edcon in Revesby, $80 so far

Never done this before, I think they turned out good for a first timer





Baz.

Originally Posted by Redback

OK I made a set of Discowhite design sliders got the steel from Edcon in Revesby, $80 so far

Never done this before, I think they turned out good for a first timer





Baz.

They look pretty good for $80
Not quite good anough judging by your doors though
I plan on making some that only cost around that much

CHEERS TIM.